Coolaroo Simple Lift 930975 Manual De Instrucciones

Congratulations on the purchase of your Coolaroo® Simple Lift™ Outdoor Roller Shade. Whether you choose to install it in your apartment or home on a
window, balcony, patio, porch or deck, simply follow the directions included here to create a safer, more enjoyable environment with increased privacy.
(4) Idle end
(2) Mounting
brackets
(8) Wood
screws
(9) Drywall
anchors
(5) Shade
(6) Bottom rail
Your Simple Lift™ Outdoor Roller Shade is fully assembled and only needs to be installed before it can be used. Before beginning the steps below, please
take a moment to review the parts list you will need to hang the shade.
Your Simple Lift™ Outdoor Roller Shade can either be hung from the top of a surface (i.e. window frame, (Fig. 1) or side mounted on the inside surface of a
wall, patio or porch. Regardless of how you choose to install the shade, the installation instructions remain the same.
1
INSTALL THE MOUNTING BRACKETS
A. Using the mounting bracket as your guide, mark the holes where the
screws will go with a pencil. The tension wheel bracket will need to be
installed on the right hand side.
Note: Be sure the brackets on both ends are level and in
line with each other.
Use a 3/16" drill bit to pre-drill the holes. If you are mounting the
B.
shade on a material other than wood The optional wall anchors which
can be inserted into the pre-drilled holes are included.
C. Mount the installation brackets to the ceiling or wall using the wood
screws provided. (Fig. 1)
2
INSTALL THE SHADE
A. Next, position the shade so that the tension wheel side of the roller
shade is on the right. (Fig. 2)
Note: You will also want to position the head rail (roll) so that
the red tension brake is facing you. This will make it easier for
you to remove the brake as described in Step E.
Outdoor Roller Shade
Simple Lift
TM
INSTRUCTION MANUAL
(1) Head rail (3) Tension wheel
component
(7) Bottom
rail cap
PARTS LIST
1 Head rail
2 Mounting brackets
3 Tension wheel component
4 Idle end
5 Shade
6 Bottom rail
7 Bottom rail cap
8 Wood screws
9 Drywall anchors
Fig.1
Fig.2
ADDITIONAL TOOLS
QTY
NEEDED
1
Screwdriver
2
Measuring tape
1
Pencil
Drill with 3/16" drill bit
1
1
1
2
4
4
20 minute set up
(approximate time)