Automatic Suction Shut-Off - Milwaukee ULINE H-8853 Manual Del Usario

NOTE: Never use water to clean filter.
6. To install the filter, slide it over the float cage. Align
the filter tabs with the motor housing notches and
turn it 1/2" clockwise to lock in place.
7. Replace the motor housing and secure both latches.
PICK-UP/BLOWER
The vacuum can be used for debris pick-up or as a
blower depending on the port used.
1. For debris pick-up, insert large end of hose into
intake port of motor housing and align tabs on hose
with notches in port. Twist to secure.
WARNING! To reduce risk of fire and injury,
do not vacuum flammable or combustible
materials. To reduce risk of injury, wear safety
goggles or glasses with side shields. Empty
tank before use.
Before use, ensure the filter and float cage are
properly installed. Remove filter before all wet
pick-up operations.
STARTING AND STOPPING VACUUM
• To turn on the vacuum, push the switch to the on (I)
position.
• To turn off the vacuum, push the switch to the off (O)
position.
WET PICK-UP OPERATIONS
1. Remove all dirt and debris found in the tank.
2. Remove the filter. Ensure that the float cage remains
in place. (See Figure 1)
Figure 1
3. Turn on the vacuum and begin pick-up.
PAGE 4 OF 15
ASSEMBLY CONTINUED
OPERATION
Float Cage
2. To use as a blower, insert the large end of hose into
the blower port of the motor housing, aligning the
tabs on the hose with the notches in the port. Twist to
secure and form a tight fit.
WARNING! Only use accessories specifically
recommended for this tool. Others may be
hazardous.
INSTALLING/REMOVING ACCESSORIES
To install the nozzles, hoses or extensions, push the
accessory onto the vacuum inlet.
4. Turn off vacuum immediately upon completing a
wet pick-up job or when tank is full and needs to be
emptied.
NOTE: If suction shuts off, turn off the vacuum
immediately and empty the tank.
5. Remove the battery pack.
6. Raise the hose to drain any excess liquid into tank.
7. Remove motor housing and pour liquid waste into a
suitable drain.
8. Clean interior of the tank and pick-up accessories
periodically, more often when used to pick up wet,
sticky materials. Use warm, soapy water.

AUTOMATIC SUCTION SHUT-OFF

When picking up liquids, an internal float rises until it
seats itself against a seal at the intake of the motor,
shutting off suction. When this happens, the motor will
develop a higher than normal pitch noise and suction
is drastically reduced. If this occurs, turn off the vacuum
immediately. Failure to turn off unit after float rises and
shuts off suction will result in extensive damage to the
motor. To continue use, empty liquid waste from tank.
NOTE: If the vacuum is accidentally tipped
over, it could lose suction. Turn off vacuum and
return it to an upright position. The float will
return to its normal position.
STORAGE
Before storing vacuum, empty and clean tank, filter and
accessories. Remove battery pack.
0820 IH-8853