ASSEMBLY
1.
Pass the cord through the hole of the bass.
2.
Insert the front case into the case and turn the butterfly screw clockwise.
3.
Pass Cord though pillar of the base.
4.
Remove the protrduded section by lifting the rib and then pulling the front grille.
5.
Remove the knob screw by turning it counter clockwise.
6.
Remove the protruded section by pulling the rear grille.
OSCILLATION CONTROL
1.
Oscillation is operated by ativating the oscillation switch.
2.
When the oscillation switch is pushed down, the oscillation is activated. When the
oscillation switch is pulled up, the oscillation is turned off.
3.
When the switch is set at OFF position, oscillation is not possible.
4.
When the timer is set at OFF position oscillation is not possible.
CAUTION
1.
Read the instructions on the manual carefully before using for the first time.
2.
Before connecting to the power source, check if the voltage specified on the
appliance corresponds with the voltage at your home.
3.
DO NOT put the appliance or the plug in water or any other liquid. However, if the
appliance did contact with liquid, unplug the appliance immediately and have it
checked with qualififed technician before using it again.
4.
Never put objects into the grille when the fan is connected to its power source.
5.
Keep an eye on children while the fan is operating. Stay out of reach for children
and do not allow them to play with the fan.
6.
It is the best not be exposed to a continuous cold air stream for a long period of
time.(esp. children and elders)
7.
DO NOT use the fan in very hot or humid environments, such as bathrooms.
8.
Keep the fan away from lace curtains, plans, etc.
9.
DO NOT connect the appliance to its power source until completely assembled and
adjusted.
10. DO NOT use if the power cord or the appliance is damaged, it must be repaired by
an authorized service representative as special tool and or parts are required.
11. Keep the cord away from traffic area or where it can be stumbled over.
12. Indoor use only.