Taurus ALPATEC FRESKO 3B Manual Del Usuario página 12

motor housing, so the holes on the blades
match the holes on the motor and fix the blades
with three screws (Fig.9).
- Pass the cables through the hole on the lamp
holder panel (Fig. 10)
- Insert the panel, so the holes match the
screws. Turn anticlockwise and fastent the
screws (Fig. 11)
- Connect the wires using the terminal block
(Fig.12).
- Place the E27 bulb (60W maximum) in the bulb
holder (Fig.13).
- Insert the glass bowl and turn clockwise to fix
it (Fig.14).
- Check the correct rotation of the blades.
- In case of some wobbling, check the instruc-
tions on the balancing kit.
ASSEMBLING THE BATTERY/IES
- Caution: During the handling of batteries, do
not touch both poles at the same time, as this
will provoke the partial discharge of the stocked
energy therefore affecting longevity.
- Remove the cover of the battery compartment.
- Check that the plastic covering that protects
the battery has been removed (some batteries
are sold with a protective covering)
- Put the battery in its compartment, respecting
the polarity.
- Replace the cover of the battery compartment.
- It is essential that the batteries should always
be the same kind and the same charge. Never
mix alkaline batteries with normal one (Car-
bon-Zinc) and/or rechargeable ones.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
USE
- Turn on the light using the on/off button (E).
- Turn the fan on using one of the speed selec-
tion buttons (H).
- NOTE: Make sure the swhitch is on so it lets
the electricity through.
TIMER FUNCTION:
- The appliance's operating time can be control-
led.
- To program the operating time, simply select it
using the timer buttons (1h, 2h, 4h, 8h) (G).
- After the selected time, the appliance will
switch off automatically.
SUMMER/WINTER FUNCTION:
- The appliance has a switch (A) that allows
changing the direction of rotation of the blades.
- The slide switch controls the direction of the
rotation, forward or backward.
- Summer (down position): the fan rotates
counterclockwise. A descending air circulation
creates a cooling effect. This allows to regulate
the air conditioner to a higher temperature
with- out affecting the comfort.
- Winter (top position): the fan rotates clockwise.
A rising air circulation moves the hot air from
the roof area. This allows the heating to be reg-
ulated at a lower temperature without affecting
the comfort.
- Turn off the fan and wait until the blades have
stopped before changing the position of the
slide switch.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance, using the STOP button (F).
- Switch off the light, using the on/off button (E).
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.