Operation - Porter Cable POCKET CUTTER 552 Manual De Instrucciones

Fig. 14
A
3. Tighten the motor clamp nut firmly.
4. Insert the motor power cord into the receptacle (Fig. 15).
5. Set the motor switch (A) Fig. 15 to the "ON" position.
TO START AND STOP THE MOTORS
circuit is the same as that specified on the specification plate of the machine.
1. Connect the machine power cord to the power source.
2. Move the switch (A) Fig. 16 to the "ON" position to start the motors.
Fig.16
3. Move the switch to "OFF" position to stop the motors.
TO LOCK THE SWITCH
The switch button acts as a key. Remove it to lock the switch in the "OFF"
position.
1. Place the switch in the "OFF" position.
2. Pull the button from the switch (Fig. 17).
B
Disconnect the tool from the power source.

OPERATION

Before connecting to power source ALWAYS MAKE SURE
THE SWITCH IS IN THE "OFF" POSITION and that the power
Make sure that your hands, the workpiece, and all foreign
objects are clear of the cutter area.
A
Disconnect the tool from the power source.
Fig. 15
Fig. 17
14
A