General Warnings
To ensure the safe installation, adjustment, and operation of the Transfer Bench, these
instructions MUST be followed. FAILURE TO FOLLOW INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY TO THE USER AND/OR DAMAGE TO THE
PRODUCT. If you are unable to understand these warnings, cautions, and instructions,
contact a healthcare professional or dealer before attempting to use this equipment.
Warnings:
Prior to each use check to assure that all screws, joints and fittings
on the transfer bench are tight.
DO NOT place the transfer bench on uneven surfaces.
DO NOT use if wobbly, unstable or not level.
DO NOT exceed user weight capacity of 350 lbs. (158 kg)
DO NOT stand on the transfer bench.
DO NOT use the transfer bench for anything but its intended purpose.
DO NOT use the armrest to fully support body weight when using the unit.
√
Excessive twisting or turning while seated on the transfer bench may cause a loss
of balance and damage to the product.
√
Check rubber tips for rips, cracks or wear. If these conditions exist, DO NOT use
the transfer bench and replace the tips immediately.
√
Check the bench for cracks or ruptures in the plastic. If you have concerns,
contact the manufacturer at 1-800-MEDLINE.
√
Check that all push buttons are fully protruded from the mainframe through the leg
extensions and are properly engaged.
√
Ensure all four legs are adjusted evenly and are free of any obstructions prior to use.
√
To release suction, use the pull tabs on the suction cups. Failure to do so will cause
damage to the product.
2
Transfer Bench Components
Note: Before assembly, ensure that all parts and quantities match the parts list. Inspect
all components for shipping damage. If any parts are missing or damaged, contact your
dealer/retailer for replacements.
A. Two Panel Section of Seat
B. One Panel Section of Seat
C. Legs with Extension (2)
D. Suction cup legs with extension (2)
E. E Clamps (4)
F.
Back Rest
G. Arm Rest
(Sections A, B and F have
a pre-assembled frame.)
A
E
MDS86960KDMB (GPI141)
MDS86960KDMB (GPI141)
Revision: 09/09/15
Revision: 09/09/15
G
B
E
D
C
B
F
G
F
A
C
D
3