Installation Instructions; Before You Begin; Important - GE WPGT9350 Instrucciones De Instalación Y Manual Del Propietario

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: www.GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and
carefully.

IMPORTANT

•
instructions for local electrical inspector's
use.
IMPORTANT
•
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level Installation of this appliance
–
requires basic mechanical skills.
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty
PLUMBING REQUIREMENTS
WATER PRESSURE – Must be 10 psi minimum
to 120 psi maximum.
WATER TEMPERATURE – Household water
heater should be set to deliver water at 120°
to 150°F (50° to 66°C) TO THE WASHER.
SHUTOFF VALVES – Both hot and cold shutoff
valves (faucets) should be supplied.
DRAIN – Water may be drained into
standpipe or set tub. Discharge height MUST
NOT BE LESS THAN 30 INCHES and no more
than 8 feet above the base of the washer.
Standpipe must be 1
inside diameter and must be open to
atmosphere.
– Save these
– Observe all
.
1 ⁄ inches minimum
2
WPGT9350, WPGT9360
FOR YOUR SAFETY:
ELECTRICAL REQUIREMENTS
CAUTION
do not use an extension cord or adapter plug
with this appliance. Do not, under any
circumstances, cut or remove the third
grounding prong from the power cord. Follow
national electrical codes and ordinances. This
appliance must be supplied with the voltage
and frequency indicated on the rating plate
(located on the rear cover of the backsplash),
and connected to an individual, properly
grounded branch circuit, protected by a
15- or 20-amp circuit breaker or time-delay
fuse. If the electric supply provided does not
meet the above requirements, call a licensed
electrician.
GROUNDING INSTRUCTIONS
This appliance must be grounded.
In the event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least resistance
for electric current. This appliance is equipped
with a cord having an equipment-grounding
conductor and a grounding plug. The plug
must be plugged into an appropriate outlet
that is properly installed and grounded in
accordance with all local codes and
ordinances.
WARNING
of the equipment-grounding conductor can
result in a risk of electric shock. Check with
a qualified electrician or serviceman if you
are in doubt as to whether the appliance is
properly grounded. Do not modify the plug
provided with the appliance—if it will not fit
the outlet, have a proper outlet installed by
a qualified electrician.
19
Washer
– For personal safety,
– Improper connection