Devon TREAD 2 Manual De Instrucciones página 6

S E C O N D S M O D E
Although the Tread 2 is not equipped with a
second belt, SECONDS mode will allow you to use the
minute belt to indicate the advancing of seconds.
To view the current seconds reading:
During normal time display, push the crown
lever DOWN momentarily. The minute belt will now
advance to the current second reading and begin
ticking.
NOTE: While in this mode you will not be able
to see the current minute reading, however, the
internal clock will continue to track the correct
time.
All manuals and user guides at all-guides.com
To exit SECONDS mode:
Push the crown lever DOWN momentarily. The
minute belt will revert back to the current minute
reading.
NOTE: Extended use in SECONDS mode causes
significant drain on the battery.
C H R O N O G R A P H
The Tread 2 is equipped with a chronograph
(stopwatch) function. When used as a chronograph,
the horizontal belt represents minutes and the
vertical belt represents seconds.
To enter CHRONOGRAPH Mode:
During normal time display, pull the crown lever
UP momentarily. The horizontal belt will advance
to 12 and the vertical belt will advance to 00.
To start or stop the chronograph:
Push the crown button IN momentarily and
RELEASE. The stopwatch will count seconds
on the vertical belt. Once 60 seconds is reached
the horizontal belt will advance to 1 to track that
a minute has passed. The stopwatch will then
automatically roll over to 1 min again after 10
minutes and 59 seconds has past.
To reset the chronograph:
Push the crown lever DOWN momentarily and
RELEASE.
To exit the chronograph:
Pull the crown lever UP momentarily. The vertical
and horizontal belts will now advance back to the
current hour and minute reading and continue
displaying the current time.
NOTE: Extended use in CHRONOGRAPH mode
causes significant drain on the battery