Before Configuration; Ie Configuration - Atlantis Land WebShare 144WN Guía Rápida

Before Configuration

This section describes the configuration required by LAN-attached PCs that
communicate with the WebShare Wireless N ADSL2+ Router, either to
configure the device, or for network access. These PCs must have an
Ethernet interface
WebShare Wireless N ADSL2+ Router either directly or through an
external repeater hub, and have TCP/IP installed and configured to obtain
an IP address through a DHCP server or a fixed IP address that must be in
the same subnet of the Wireless N ADSL2+
address of the WebShare Wireless N ADSL2+ Router is 192.168.1.254
and subnet mask is 255.255.255.0. The best and easy way is to configure
the PC (client DHCP) to get an IP address from the WebShare Wireless N
ADSL2+ Router.
Please follow the steps below for PC's network environment installation.
First of all, please check your PC's network components. The TCP/IP
protocol stack and Ethernet network adapter must be installed. If not,
please refer to MS Windows relative manuals.
Before you configure this WebShare Wireless N ADSL2+ Router, you need
to know the following default settings:

Username: admin

Password: atlantis

IP address (192.168.1.254), Subnet Mask (255.255.255.0)

DHCP Server: enable (from 192.168.1.100 to 192.168.1.199)

WAN=PPPoA Routing, VPI=8, VCI=35, VC-Mux

SSSID= A02-RA144-W300N, Channel=6, WEP/WPA=disable

1.6 IE Configuration

Now open IE, go to Instruments menu, select the Connections tab and
select one of the following options:

Never use remote connection

Use remote connection if another network connection isn't
available
installed properly,
WebShare 144WN
ENGLISH
be connected
Router. The default IP
to the
32