TC Electronic TC ICON DOCK Guía De Inicio Rápida página 6

10 TC ICON DOCK
Features
Thank you for purchasing the TC ICON DOCK. Please read through this Quick Start
Guide to get things set up.
The TC ICON DOCK features include:
• Dock, power and connect your TC Electronic Icon Series controllers, such as the
TC2290 and DVR250, in one sleek and tidy unit
• Integrated USB hub for tidy cable runs, connect to your computer with a single
USB cable
• Non-slip pads for secure desktop placement
• Rack ears included for rack mounting
• Universal power supply adapter included
• Internal USB connection for controllers
• + 2 m USB extension cable for computer included
• The TC ICON DOCK can hold up to 7 Icon Series Desktop Controllers
• The space at the far right will fit a "2-unit wide" controller such as the TC2290
Dynamic Digital Delay or the DVR250 Digital Vintage Reverb. A "1-unit wide"
controller can also be installed there, as the USB cables are long enough.
• Otherwise all positions are identical and can hold any of the Icon Series
Desktop Controllers
Mounting Rail
USB connectors connect to Desktop Controllers.
Note: Remove protective USB covers before use
DC Input
Removable
Rack Ears
Note: Side plates (supplied) are used
when the Rack Ears are not used
The following products are currently available in the TC ICON SERIES, and all are
compatible with the TC ICON DOCK:
• TC2290-DT Dynamic Digital Delay
• DVR250-DT Digital Vintage Reverb
• TC8210-DT Classic reverb
• TC1210-DT Spatial Expander
• MASTER X HD-DT Multiband Dynamics Processor
• BRICKWALL HD-DT Mastering Brickwall Limiter
• PEQ 3000-DT Midas-Powered Parametric Channel EQ Plug-In
• DYN 3000-DT Midas-Powered High-End Dynamics Channel Plug-In
PCB
Front Edge Rail
Removable
Rack Ears
Micro USB B
Non-Slip Pads
Rack Ear Installation
Follow the instructions below to make the TC ICON DOCK compatible with 19" rack.
CAUTION: Make sure that the power supply adapter and USB connections are unplugged from the unit before proceeding.
CAUTION: as there is no power switch, make sure the power connection is readily accessable when the TC ICON DOCK is installed in a rack.
Note that the power connection and USB cable need some extra space in the rack above the TC ICON DOCK. (Allow 1U rack space or more.)
1. Undo the 6 screws and remove the end plates. Keep them in a safe place in case you want to use them again.
2. Install the rack ears on each end, using the same screws. Tighten the screws securely.
4U
Quick Start Guide
19"
11