MARTINS Industries MFJ-30T Manual Del Usario página 5

OPERATIONS
Only use this device once you have read the
instruction manual and / or have been trained
by your employer. The product should only
be used to lift vehicules within the maximum
load capacity.
Wear safety boots while using the device.
The floor jack is not designed to maintain heavy loads for long period of time. Do not place any parts of body under
the load without jacks stands in place. Before lowering the load, ensure that there no obstructions underneath and
that all people are standing clear.
PRIOR TO LIFTING
1. Set the parking gear and engage the parking brake.
1.1 Vehicle with manual transmission.
1.1.1 Engage the parking brake and leave the car in reverse or 1
2. Unlock lever to release the handle.
3. Center jack saddle under lift point. (refer to vehicule owner's manual)
4. Activate the switch to lift, until you reach the desire height.
5. Transfer the load to Jack stands.
LOWERING
1. Raise load with floor jack high enough to clear the jack stands.
2. Carefully remove the jack stands.
3. Activate the switch to lower the vehicule, until initial position.
4. Always remove the floor jack once the load is on the ground.
Always use on a stable and level surface.
Always check the stability of the vehicle before use, to prevent injuries
and/or damages.
Do not exceed maximum load capacity.
gear. (refer to vehicule owner's manual).
st