Installation Instructions
Please read before installing
The QS Harness Kit for DIN Panels is meant to connect the QS
communication link between all DPM modules in the panel and
terminate to a wire landing board at the bottom of the panel. The
harness connects communication only (Pins 1, 3, 4).
1. Turn power off to all feeds to the panel.
WARNING – Shock hazard. May result in serious injury or
death. This may be fed by multiple circuits. Locate and lock
each supply breaker in the off position before proceeding.
2. Identify components. Confirm all parts are in the kit.
PDW-QS-4
PDW-QS-5
PDW-QS-8
PDW-QS-9
PDW-QS-10
3. Remove installed 4-position connector shipped with module.
Locate the 4-position connector meant for QS Link wiring on each
module in the panel. Once located, remove all connectors.
4-Position Connector Removal
800 W Max
500 W Max
500 W Max 500 W Max
CCI
Zone 1
Zone 2
Zone 3 Zone 4
Option
Input
H
Def
Hi T emp
Opt1
M
Prog
L
Opt2
Power
Opt3
www.lutron.com +44.(0)20.7702.0657
230 V~ 50 / 60 Hz 10 A
LQSE-4A-D module shown
Need Help? www.lutron.com/support or call
Customer Assistance at 1.844.LUTRON1
Customer Assistance: Europe: +44.(0)20.7680.4481 | Asia: +86.21.61650990 | Other Countries: +1.610.282.3800 | www.lutron.com/support
Lutron Electronics Co., Inc. | 7200 Suter Road | Coopersburg, PA 18036-1299 USA
QS Harness Kit
for DIN Panels
PDW-QS
Remove
L
L
N
N
N
N
N
DL1 DL2 DL3 DL4
4. Install QS wiring harness. Once all 4-position QS connectors have
been removed from modules, install QS wiring harness as shown
below.
Note: Lutron recommends securing any unused connectors.
QS Wiring Harness
5-position
connector
Warranty: For Warranty information, please see the Warranty enclosed with the
product, or visit www.lutron.com/TechnicalDocumentLibrary/Intl_Warranty.pdf
Lutron and
are trademarks or registered trademarks of Lutron Electronics Co., Inc.
)
in the US and/or other countries.
©2019 Lutron Electronics Co., Inc.
English
P/N 043521 Rev. A
08/2019
4-position
connector
QS Wiring
Harness
QS Wiring
Harness