EN
GENERAL INFORMATION
1.2
Other markings in this documentation
Safety
Symbol
meaning
Material damage
(Damage to units and environment, consequential loss
and damage)
Appliance disposal
This symbol tells you that you must do something in
particular. The required actions are described step by step.
1.3
Units of measurement
Important
All measurements are in millimetres unless indicated otherwise.
2.
Safety
2.1
Proper use
The hot water boiler heats up drinking water above boiling point. This combination is
intended for homes and similar applications. Any usage differing from or exceeding
this intended use is considered incorrect. Correct usage also includes observing these
instructions.
2.2
General safety instructions
CAUTION - burns
The fi tting can increase in temperature to over 60 °C.
There is a risk of burns at discharge temperatures greater than 43 °C.
WARNING - injury
Children over 8 years old and people with reduced physical, sensory or mental
capabilities or lacking in experience and knowledge may only use the unit under
supervision and after a suitable briefi ng and if they are aware of the related risks
and hazards. Children under 8 years old must not use the unit. Supervise
children to ensure that they do not play with the system.
18
GENERAL INFORMATION
Material damage
The user must protect the system against frost.
Material damage
Discolouration may arise if boiling water is allowed to splash onto the
same spot on composite kitchen sinks on a constant basis.
2.3
CE marking
The CE marking provides proof that the system complies with all basic requirements:
- Low Voltage Directive 2014/35/EU
- EMC Directive on Electromagnetic Compatibility 2014/30/EU
Harmonised standards:
EN 60335-1:2012, EN 60335-2-21:2012 A1:2018-CSV
2.4
Certifi cation mark
See rating plate on the boiler.
INSTALLATION
3.
Safety
Only a trained technician may install the boiler, put it into operation and maintain it.
Only the manufacturer may carry out repairs to the boiler.
3.1
General safety instructions
We can only guarantee that the boiler will function perfectly and safely if you operate
it with an appropriate BLANCO fi tting and the matching BLANCO safety assembly
module and install these components properly. Use only the original accessories and
original spare parts for the system.
3.2
Regulations, industrial standards and legislation
Important
Observe all national and regional regulations and legislation.
EN
19