Charging Procedure; Intended Use; Charging Indicator - Ratio AR144-3NM Manual De Instrucciones

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic
and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not use
another battery charger.
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the Battery Pack Release Button (7)
firmly first and then slide the Battery Pack out
from your tool.
C) TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
A1
A2
D) HOW TO CHARGE YOUR BATTERY PACK
(See Fig. A3)
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, the
light will turn to red to indicate the charging
process has started.
3) When charging is completed, the light will
turn to green. The pack is now fully charged,
unplug the charger and remove the battery
pack.
WARNING: When battery charge runs
out after continuously use or exposure to
direct sunlight or heat, allow time for the tool to
cool down before re-charging to achieve the full
charge.

CHARGING INDICATOR

This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem as the
original Battery Pack, have the charger tested at
an authorized service center.
Light ON/OFF flash
Red on
Red flash
Green on
Green flash
A3
Status
Charging
Defective
Battery
Fully Charged
Hot/Cold Delay
39