Baldwin RESERVE PFEDTAR Manual De Instrucciones

1. Adjust and install latch
Measure your door backset as shown.
If backset of door measured
2-3/4" (70mm), adjust latch shown
by grasping the spring pin and
moving it to the 2-3/4" slot.
Pin
LATCH ASSeMbLy AND INSTALLATION
Make sure the slant of latch bolt faces in the direction that the door closes.
For Square Corner and Round Corner
OR
Snap together front and back plate.
For Drive In Latch
Snap on collar.
Drive in with hammer.
2. Install spindle
If not already installed, insert
the half round spindle
into exterior chassis.
3. Install chassis
Push and hold in latch bolt, align curve of half round spindle
with latch, and install exterior chassis.
exterior chassis
Note: For privacy knob or lever, make
sure the toggle is in the unlocked
position closest to the latch.
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
TeMPLATe
2-1/4"
(57 mm)
1-3/4"
(44 mm)
2" 2-3/8" 60mm
(51 mm)
1-3/8"
(35 mm)
2-1/2"
2-3/4" 70mm
(64 mm)
Install with 1/2" screws.
Align curve of half
round spindle with
interior chassis and
install with screws.
interior chassis
Fold
Doble
Plier
Centerline
Ligne médiane
Linea central
Privacy/Passage Knob and Lever Installation Instructions
www.baldwinhardware.com • Customer Service 1.800.437.7448
4. Install knob/lever
Place knob or lever onto chassis and turn set screw clockwise to secure.
Repeat for knob or lever on the other side.
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
5. Install strike
Save the bedroom/bathroom emergency unlock tool for future use.
For privacy function only.
THICK DOOR KIT INSTALLATION INSTRUCTIONS
(AvAILAbLe SePARATeLy)
Supports 2" (51 mm) up to 2-1/2" (64 mm) doors
After the completion of Step 1, install the longer half round spindle
supplied in the kit. Install the privacy pin on privacy products only. Proceed
to Step 3 and install with longer screws. During Step 5, install strike
supplied in the kit.
privacy pin
(for privacy function only)
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
Copyright © 2011 Baldwin Hardware Corporation
Fits 1-3/8" (40 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
Please note: Product
illustrations may differ
from your product.
Installation is the same.
Adjust tang as needed.
exterior chassis
longer half
round spindle
1"
25mm
Measure
after printing.
25mm
47038 / 01
1" 1"
25mm