Abicor Binzel ABIDOT Instructivo De Servicio página 26

Ocultar thumbs Ver también para ABIDOT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6 Putting into operation
6.2 Mounting the ABIDOT
6.2.1 Adjusting the stick-out
1
6
5
1
Hexagon socket screw M3x4
type:
2
Torch adaptor
Fig. 5
Adjusting the stick-out
EN - 10
NOTE
• Before mounting the ABIDOT, you must mount the corresponding
welding torch on the robot and adjust the desired stick-out at the
ABIDOT. Make sure to use the suitable torch adaptor.
3
Torch adaptor type: W500,
A360, A500
455D TS, 505, VTS500
4
Torch adaptor type: W600,
650TS, 652D TS
1 Loosen the hexagon socket screw (1), but do not remove it.
NOTE
• The torch adaptor to be used depends on the corresponding welding
torch type.
2 Mount the appropriate torch adaptor (2), (3) or (4) in the ABIDOT (5) by
slightly lifting the (6) clamping piece.
3 Adjust the stick-out by means of the corresponding torch adaptor.
Slide in the torch adaptor over the locking until the desired setting is
reached.
 see Fig. 6 Details torch adaptor on page EN-11 and Fig. 7 Setting in torch
adapter on page EN-11
2
3
4
5
ABIDOT
6
Clamping piece
ABIDOT

Publicidad

Tabla de contenido
loading

Tabla de contenido