Cleaning The Device; Technical Data - Adler europe AD 2177 Manual De Uso

water.
21. Do not use when standing. Only use in sitting possition.
22. FIll the device only with water. Do not use any oils or bathing solutions, gels and
substances.
23. If you have any concerns about your health please contact a phisician before use.
Users with heart problems, heart pacemakers, diabedic or other health problems. Pregnant
women and users complaining on prelonged joint and muscle pains. Long lasting and
frequent pains may be warning sighns of serious ilness please consult a Doctor.
24. Do not use the device more than 10 minutes without breaks.
DESCRIPTION OF THE DEVICE (fig 1)
1 Anti-splash cover
4 Transport handle
7 Aromatherapy diffuser
DEVICE UTILIZATION
1. Make sure that the device is disconnected from the power, and the power knob is set to "off" position.
2. Fill the tank with warm or cold water, depending on your preferences. Do not fill above MAX mark. NOTICE: The device has a
water heating function. in 2 of 3 of the work modes.
3. Connect the massager to the power. Never unplug the massager if your feet are immersed in water.
4. Sit comfortably and put the feet in the massager. Never stand on the massager.
5. Choose one of available massaging programmes (fig 2).
- 2: Vibration and bubble massage in cold water
- 3: Increasing the water temperature, infrared and heater on. (no more than 45°C)
- 4: Infrared, Vibration massage, increasing water temperature (no more than 45°C), bubble massage.
6. After using the massager switch the power knob to "off" position, remove feet from the water and wipe them dry. Disconnect the
massager from the power circuit.
7. Wait until the device cools, clean according to the description in "Cleaning the device" section.
AROMATHERAPY DIFFUSER:
Before filling with water, remove the aromatherapy diffuser lid, pour in a few drops of your chosen oil(s) onto a small piece of sponge
and place into the diffuser compartment, or place a crushed herbal bath bomb, fresh crushed herbs or rose petals directly into the
diffuser compartment. Replace lid and then fill with the water.

CLEANING THE DEVICE

1. Make sure that the device is disconnected from the power and is not warm.
2. Never immerse whole device in water.
3. In order to clean the device, use cloth with washing-up liquid. Rinse the massager bowl and wipe dry.
NOTICE: Do not immerse the massager in water or other liquids to avoid water penetrating into the inside of device. Never pour
water over the controller.

TECHNICAL DATA

Supply voltage: 220-240V~50/60 Hz
Power: 450W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
2 Red light
5 Reflexology foot Rollers 6. Hydrotherapy jets
8 Controller
Device is made in class II of insulation.
Device is compliant with EU directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
3. Device double walls.
9 Water tank