Gemini GSYS-2000 Manual Del Usuario página 6

6
SPECIFICATIONS
AUDIO
Output Power
Frequency Range
Input Voltage
SPEAKERS
Subwoofers
Tweeters
OTHER
S/N Ratio: ≥ 70dB
Input Sensitivity: 500mV±50mV
Input Voltage: AC100V-240V 50/60Hz±10%
Support electric guitar/keyboard: Yes
FM Antenna: Telescopic FM antenna (20 FM
preset channels)
USB port: support MP3/WAV playback
Specifications subject to change without
notification for improvement.
TROUBLESHOOTING
UNIT WILL NOT POWER ON
• Check power cord is securely connected to mains
power and wall outlet is powered and not
switched.
CAN'T CONNECT VIA BLUETOOTH
• Make sure BLUETOOTH on your portable
device is turned on.
• Make sure GSYS-2000 is in BLUETOOTH
mode.
• Verify another Bluetooth device is not
currently connected to unit.
CAN'T HEAR BLUETOOTH OR EXTERNAL
DEVICE
• Verify power is on and volume is turned up on your
external device.
MICROPHONE IS NOT AUDIBLE
• Slowly raise MIC LEVEL until mic is audible.
• Make sure microphone is fully plugged in and turned
on (if switched).
For all other issues, please contact GEMINI support
at 1-844-GEMINI9
800W Peak
20Hz to 20KHz
100V – 240 VAC
50/60Hz + 10%
Dual 8"
Dual 3"
GSYS-2000
DUAL 8" BLUETOOTH PARTY SYSTEM
Responsible Party Name:
Innovative Concepts & Designs
Company address:
107 Trumbull St-F8 2nd Floor
Elizabeth, NJ, 07206 USA
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
The operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter.
The device has been evaluated to meet general RF
exposure requirements. The device can be used in
portable exposure conditions without restriction.
Note: This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
interference to radio or television reception, which
then on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC ID: 2AE6G-GSYS2000