Pairing In Rx Mode; Pairing With A Smartphone; Use; Switching On - Vogel's SAVA 1001 Modo De Empleo

4.3.3

Pairing in RX mode

Connect the SAVA 1001 to your audio system using the correct
connection cable (C, D or E).
Slide the multifunctional switch (2) all the way to the right (BT).
The LED will now start to blink red/blue, indicating that the SAVA
1001 is ready for pairing. Now slide the multifunctional switch back
to the centre position for optical connection (OPT), or all the way
to the left for analogue connection (AUX).
4.3.4

Pairing with a smartphone

Turn on Bluetooth on your smartphone and scan for Bluetooth
devices. Select the SAVA 1001 to pair and connect. Once the
connection has been established, the LED will turn blue or green.
The music from your smartphone is now played through your
audio system.
5

Use

5.1.1

Switching on

The SAVA 1001 does not start connecting to your devices if these
are already switched on. Therefore, it is advisable to switch on the
SAVA 1001 first, followed by the previously connected devices.
5.1.2

Re-pairing

Previously paired Bluetooth devices connect automatically with
the SAVA 1001 when switched on.
5.1.3

Adjusting the volume

The SAVA 1001 is a passive transmitter or receiver and does not
have volume settings. The desired volume level must be set on
the devices that are paired with the SAVA 1001.
5.1.4

Removing paired devices

To remove previously paired devices from memory, please follow
these steps:
Ensure that the SAVA 1001 is switched on in RX or TX mode.
Slide the multifunctional switch (2) all the way to the right (BT) for
6 seconds.
The LED will first flash red/blue and then turns red/blue constantly.
SAVA 1001
11