Putting On The Respirator - Honeywell NORTH 7600 Serie Manual De Instrucciones

PUTTING ON THE RESPIRATOR

Follow INSPECTION directions 1 through 4, then tug once more on the cartridges or filters to assure
they are securely attached.
1) Remove your hard hat or other headgear prior to putting on your respirator.
2) Adjust the head straps of the respirator to their full outward position by pulling up on the tabs to
release the strap tension, then pulling the straps outward.
3) Grasp the harness by placing your hands in the harness and your thumbs between the lower
straps (Figure 6).
4) Push the harness up on your forehead, brushing your hair upward from the seal area (Figure 7).
Continue up and over your head until the harness is centered at the rear of your head and your
chin fits into the chin cup (Figure 8).
5) Beginning with the lower straps, pull on the end tabs in small, equal increments to ensure they are
tightened evenly.
6) Tighten the upper straps in small, equal increments.
7) Tighten the top strap until the entire facepiece is snug, comfortable and centered on your face
(Figure 9).
Do not use your respirator if you cannot achieve a good facepiece-to-face seal due to:
1. Facial hair, including stubble,
2. Eyewear with temples that interfere with the sealing area,
3. Head or face coverings, jewelry or any other items that interfere with the sealing area, or
4. Missing teeth or dentures, facial deformities or deep scars that prevent a good seal.
Failure to follow these warnings will result in the risk of serious injury, illness or death.
WARNING
12
Figure 6
Figure 7
Figure 8
Figure 9