Kohler K-3091 Guia De Instalacion página 6

1. Install the "Z" Mounting Bar and Top Clips
Each cabinet is shipped with an aluminum "Z" mounting bar
which mounts to the wall to support the weight of the cabinet.
The bar should be installed in the center of the bottom brace (if
applicable).
Use a pencil to mark the wall where the bottom of the cabinet
will be located. Use a level to draw a horizontal line the length of
the mounting bar. If installing multiple cabinets side-by-side, use
a level to draw horizontal lines for each "Z" mounting bar.
Place the bottom edge of the "Z" mounting bar against the
horizontal line. Drill a minimum of three evenly spaced 7/32"
holes into the "Z" mounting bar through the indentations (holes
should line up with a stud behind the wall if no header was
installed).
NOTE: Use the plastic anchors supplied if no brace was placed in
the wall. Make sure each "Z" mounting bar has a minimum of three
anchors for each cabinet.
Use the #10 x 2" pan head thread cut screws (supplied) to secure
the "Z" mounting bar to the wall.
Locate the three top clips for the cabinet and slide the clips into
the groove located in the channel on the top side of the cabinet.
1012595-2-A 6 Kohler Co.