Fan Installation Instructions - Svan SVVE52TM Manual Usuario

FAN INSTALLATION INSTRUCTIONS

IMPORTANT: Power supply must be switched off prior to any contact with electrical wires. It is
recommended to get a licensed electrician to install your ceiling fan.
12. Check to make sure blades are at least 0,76m from
any obstruction. Check down rod length to ensure
blades are at least 2.1m above the floor. For higher
ceilings you may want to use an extension rod and
safety cable. A longer extension rod will be needed to
ensure proper blade clearance.
13. Install the mounting bracket to the junction box.
NOTE: the junction box must special for ceiling fan
type. If using the existing bracket, make sure the
bracket is securely attached to the building structure
and can support the full weight of the fan.
14. Carefully place the first blade onto the motor
assembly such that the large mounting flange with
three hales aligns with the three matching holes of
the motor. Install the three screws into the blade
holes and loosely fasten to the motor with a
screwdriver. Repeat for the other two blades.
15. Remove one of the three screws form the motor hub,
retain the screw for future use. Loosen the remaining
two screws. Position the switch housing keyhole slots
onto the two loosened screw heads. Rotate it
clockwise to engage the two screws. Reinstall the
previously removed screw. Retighten all three screws
to securely attach the switch housing to the motor
assembly.