Renfert MT plus Manual Del Usuario página 7

Introduction
This Quick Start Guide contains instructions on the operation of the product
and relevant safety information.
Detailed information on the product can be found in the operating instructions
which are available for download on our website at www.renfert.com/p915.
Enter the following item number: 18030000 or 18030500.
Symbols
In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
Other symbols are explained as they occur.
Safety
Proper Use
The MTplus is a model trimmer designed for use in dental technology operations to grind plaster models.
It can be employed as either a wet or dry trimmer.
Improper Use
This appliance may not be used for gringing investment material.
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
Hazard and Warning Information
General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device can
no longer be guaranteed.
► Risk of injury!
Risk of injury if the components used are not approved.
Always use original Renfert components.
► The device may only be operated using a mains cable with the country-specific plug system. Any
necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE VDE 0701-0702
(Association for Electrical, Electronic and Information Technology).
- 1 -
EN