Commissioning The Receiver - REV FR-74 Manual Del Usuario

Lens cap for the infrared sensor (7)
The area monitored by the movement sensor can be altered by
using the accompanying lans cap
the sensor lens. The lateral areas are shielded by the slit in
such a way, that only a small area (vertical or horizontal) is still
monitored. The range of the infrared sensor amounts to approx.
5 meters and with opening range of approx. 140° (Fig. A+B).

Commissioning the receiver

Installing the receiver
When plugging in the receiver (9), make sure it is within the
radio range of the transmitter. The control lamp showing that
the receiver is operational
(11)
signal lamp then flashes for approx. 15 sec. and after this
the receiver is operational.
A three-position volume switch
the receiver. You can set this to:
signal lamp cannot be turned off.
When the transmitter is activated, the receiver lets out a double
"DING-DONG" signla.tone simultaneously. Following this, the
(11)
signal lamp flashes for approx. 15 sec. Even if the switch
(2)
on the transmitter is set to
makes a "DING-DONG"
If the receiver does not react when the transmitter is activated,
plug it into a socket closer to the transmitter and check the
function again.
(7).
Place the lens cap over
(9)
(10)
will light up "GREEN"
(12)
is located on the back of
"
" " , the receiver only
sound (no alarm tone).
. The
" . The
16