Sentry STBC101 Guia De Inicio Rapido

SUMP PUMP
COMBO
Pre-assembled
Back-up Sump
Pump System
MODEL #STBC101
B
A
C
A Primary/backup pump and pipe
assembly
B Battery box with built-in controller
C AC wall adapter
QUICK START GUIDE. SEE INSTRUCTION
MANUAL FOR COMPLETE DETAILS.
AC Adapter Float Switch Pump Cord
Cord Cord
FLOAT
ADAPTER SWITCH PUMP
NOTE: The alarm will sound after connecting
the battery. It will continue to sound until all
connections are made and the float switch is in
the down position.
4. Connect system wires to the controller on the
top of the battery box lid.
NOTE: The pump will continue to run for an
additional 10 seconds after the float has been
lowered. The alarm will continue to sound while
the pump is working.
BasementSentry.com Toll Free Help Line: 1-800-742-5044
1. Unplug the existing sump pump and separate
it from the discharge pipe. Remove the pump
from the sump basin.
5. Fill the basin with water to check operation.
Schedule 40
PVC pipe
2. Place the replacement combo system in the
basin and connect it to the existing discharge
pipe.
6. Install a basin cover and gasket on top of the
basin.
3. Place a fully-charged Basement Sentry brand
battery in the battery box. Connect the leads
inside the battery box from the controller to the
battery: Red (+) to battery Red (+), Black (-) to
battery Black (-)
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
BATTERY ACID IS CORROSIVE. DO NOT SPILL ON
SKIN, CLOTHING OR BATTERY CHARGER. WEAR
EYE AND HEAD PROTECTION WHEN WORKING
WITH BATTERY. CONNECT AND DISCONNECT DC
OUTPUT TERMINALS ONLY AFTER REMOVING THE
CHARGER FROM THE AC OUTLET. NEVER ALLOW
THE DC TERMINALS TO TOUCH EACH OTHER.
KEEP SPARKS AND FLAME ( PILOT LIGHT ) AWAY
FROM BATTERY.
BE SURE TO READ AND UNDERSTAND
INSTRUCTIONS BEFORE INSTALLING OR
OPERATING THIS PUMP.
SW1475 A