Selecting The Angle Of Rotation; Pre-Selecting The Speed; Switching On / Off; Maintenance And Cleaning - Parkside PEBH 1010 Instrucciones De Utilización Y De Seguridad

Preparing for use / Maintenance and Cleaning / Disposal

Selecting the Angle of rotation

Q
Select the direction of rotation by setting the rotation
direction switch .
7
WArnInG! Do not use or set the rotation
direction switch unless the device has come to a
7
standstill.

Pre-selecting the Speed

Q
With the wheel on the speed pre-selector
can pre-select the operating speed to your individu-
al requirements.
If a low speed has been pre-selected, the on / oFF
switch is automatically restricted in the extent to
4
which it can be pulled back (due to the reduced
speed of rotation).
recommended speed ranges:
(non-binding; if necessary, you should determine
the correct setting by a practical test):
- High-speed: for hammer drilling in concrete or
stone and for chiselling
- Medium speed: for drilling into steel or wood
- Low speed: for screwing
Low speed / high speed:
j
Turn the wheel for speed pre-selection
The on / oFF switch
4
control.
j
By pressing the switch you can increase the
speed continuously.

Switching On / OFF

Q
When operating the hammer drill you can choose
between temporary and permanent operation. Use
the temporary operation for small jobs and perma-
nent operation for long jobs. Your desired setting is
operated as follows:
Switching on temporary operation:
j
Press the on / oFF switch
32 GB/MT
All manuals and user guides at all-guides.com
you
6
.
6
has a variable speed
.
4
Switching off temporary operation:
j
Release the on / oFF switch
Switching on permanent operation:
j
Press the on / oFF switch
on position by means of the locking button
Switching off permanent operation:
j
Press the on / oFF switch
again.

Maintenance and cleaning

Q
WArnInG! DAnGEr OF InJUrY!
Always pull the mains plug out of the socket before
doing any work on the device.
j
Always keep the device clean, dry and free of
oil or grease.
j
no liquids must be allowed to enter the hammer
drill.
j
Clean the hammer drill regularly, preferably
always immediately after finishing your work.
j
Please use a dry cloth for cleaning the housing.
Under no circumstances should you use petrol,
solvent or cleaning agents which might attack
the plastic.
j
Clean the tool holder
cAUTIOn! UnDEr TEnSIOn! To do so,
pull the locking / unlocking cap
rear and lever off the rubber dust protection
cap . Release the locking / unlocking cap
2
slowly.
j
Clean the components with a brush and apply
a small amount of grease to them.

Disposal

Q
The packaging is wholly composed of
environmentally-friendly materials that can
be disposed of at a local recycling centre.
Do not dispose of electrical
power tools with the household
rubbish!
.
4
and lock it in the
4
.
5
and release it
4
regularly.
1
towards the
3
3