Uline H-6100 Manual Del Usuario página 3

WALL OR CEILING MOUNT APPLICATIONS
NOTE: Hardware package is located in
styrofoam packaging.
ATTACHING HEATER TO WALL BRACKET
1. Line up hole on bracket with hole on the heater
handle. Attach heater to bracket with 20 mm bolt,
lock washer, 10 mm washer and 10 mm nut.
(See Figures 1-2)
Figure 1
Figure 2
WARNING! Be certain adjustment knobs are
tightened firmly to secure heater to bracket.
PAGE 3 OF 15
WALL MOUNT
20 mm Bolt
Lock Washer
10 mm Washer
10 mm Nut
CEILING MOUNT
INSTALLATION
MOUNTING TO WALL OR CEILING
1. Locate wood stud in wall or joist in ceiling.
2. Use holes in bracket to mark three holes for drilling.
3. Pre-drill three holes for screws. Be sure holes are
drilled into the wood stud in wall or joist in ceiling.
4. Secure two 66 mm screws to wall leaving 1/8" exposed.
Two screws must be attached to a wood stud (min. 1.5").
(See Figure 3)
Figure 3
5. Attach bracket to wall by inserting screws through
keyholes on bracket and pushing down to lock in place.
(See Figure 4).
Figure 4
6. Tighten screws against bracket to secure.
7. Insert the third 66 mm screw with a washer through
the middle hole on bracket. Tighten screw against
bracket to secure. (See Figure 5)
Figure 5
WARNING! Heater must be attached to a joist
with a minimum of two screws in opposing
holes.
WARNING! Use appropriate fasteners. The
screws included are for installing in wood studs
only and are not intended for metal joists.
66 mm Screw
0521 IH-6100