Working Instructions; Safety Instructions - Ega Master MASTERMATIC-1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Use Ega Master threading heads.
2. Always use the support; fastening it correctly to avoid the machine from rotating around the pipe
(especially when threading the biggest sizes).
3. Check that the ON switch maintains the motor functioning only when it is pressed; and stops the motor
when it is released.
4. Whenever you use an extension cable you must unroll it completely.
5. Select the direction of the rotation with the reverse speed lever.
6. Insert the machine on to the pipe and make sure that the support is securely guided into its housing
located on the machine.
7. When starting the threading, push slightly the head against the pipe.
8. As soon as the threading and once the threading length has been achieved stop the motor. Change the
position of the reverse gear and start the motor to begin unscrewing.
9. Use oil abundantly when threading to improve the life and quality of the thread.
Attention! Be careful.
1. Do not wear loose clothing. They could be
caught by moving parts of the machine.
2. For outdoor work, rubber gloves must be worn.
3. Before starting up the machine, check that the
electric cable and switch are in optimum
condition.
4. Before carrying out any maintenance work or
change of accesories, disconnect the machine
from the mains.
5. Always
use
accesories because if you don´t, it could lead to
risk of personal injury.
MAINTENANCE
Always carry out any job on the machine with the
machine disconnected.
1. Pipe Fastener Support
Check that the teeth of the jaws are in optimum
condition; if not, replace them.

WORKING INSTRUCTIONS

SAFETY INSTRUCTIONS

the
machine´s
indicicated
2. Gear Box
Maintenance is not required because it has
special grease which is good for life.
3. Brushes
Clean them and check the condition of the slack,
changing the brushes when the slack reaches 2/3
of the total.
4. On switch
Check
that
the
automatically when finger pressure is released,
stopping the motor rotation.
Note: For any necessary repairs, contact with our
Technical Services.
4
machine
switch
unblocks

Publicidad

Tabla de contenido
loading

Tabla de contenido