Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Frame Rail
Receiver Shown In Proper Position
Hitch Requires 5/8" Pin and Clip
Equipment Required:
Fastener Kit: F65031
Wrenches: 3/4", 18mm, 19mm
Drill Bits: 1/2"
1
Qty. (2)
Hex Bolt, 1/2"-13 x 1-3/4"
2
Qty. (2)
Lock Washer, 1/2"
3
Qty. (2)
Flat Washer, 1/2"
1.
Remove skid plates and tow hooks from vehicle and return to customer.
2.
Raise receiver into position and install four (4) M12 bolts.
3.
Using receiver as a template, drill two (2) holes in frame.
4.
Insert handle nuts thru access holes in frame and install two (2) 1/2"-13 bolts as shown.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Toyota Tundra
Toyota Sequoia
Fascia
Frame Rail
Existing Weldnuts
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft (92 N-m).
Tighten all 1/2" GR5 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Access Hole
4
Qty. (2)
Handle Nut, 1/2"
5
Qty. (4)
Hex Bolt, M12 x 1.25 x 35
6
Qty. (4)
Conical Washer, 1/2"
Sheet 1 of 3
N65031
Part Numbers:
65031
LB. MAX. WINCH LINE PULL
11-07-05
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 65031
Resumen de contenidos para Cequent Towing Products 65031
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 N65031 11-07-05 Rev. A 2005 Cequent Towing Products...
- Página 2 Ne pas découper, souder ni modifier l’attelage. Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage Feuille 2 de 3 N65031 11-07-05 Rev. A 2005 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 N65031 11-07-05 Rev. A 2005 Cequent Towing Products...