Coolaroo Spring Operated Manual De Instrucciones

Congratulations on the purchase of your Coolaroo® Spring Operated Outdoor Roller Shade. Whether you choose to install it in your
apartment or home on a window, balcony, patio, porch or deck, simply follow the directions included here to create a safer, more enjoyable
environment with increased privacy.
(4) Idle end
(2) Mounting
brackets
(8) Wood
screws
(9) Drywall
anchors
(5) Shade
(6) Bottom rail
ADDITIONAL
Screwdriver
Measuring tape
TOOLS
Pencil
NEEDED
Drill with 3/32" drill bit
Please take a moment to review the parts list before beginning the steps below. Your Spring Operated Outdoor Roller Shade can either be
hung from the top of a surface i.e. window frame, (Fig. 1) or side mounted on the inside surface of a wall, patio or porch. Regardless of how
you choose to install the shade, the installation instructions remain the same.
1
INSTALL THE MOUNTING BRACKETS
A.
Using the mounting bracket as your guide, mark the holes
where the screws will go with a pencil. The tension wheel
component will need to be installed on the right hand side.
Note: Be sure the mounting brackets on both ends
are level and in line with each other.
B.
Use a 3/32" drill bit to pre-drill the holes. If you are mounting
the shade on a material other than wood, use the optional wall
anchors which can be inserted into the pre-drilled holes.
C.
Install the mounting brackets to the top of a surface or inside of
the surface area using the wood screws provided. (Fig. 1)
2
INSTALL THE SHADE
A.
Position the shade so that the tension wheel component is on
the right. (Fig. 2)
Note: You will also want to position the head rail so
that the red tension brake is facing you. This will make
it easier for you to remove the brake as described in
step E.
Spring Operated
Outdoor Roller Shade
INSTRUCTION MANUAL
(1) Head rail (3) Tension wheel
component
(7) Bottom
rail cap
20 minute set up
(approximate time)
PARTS LIST
1 Head rail
2 Mounting brackets
3 Tension wheel component
4 Idle end
5 Shade
6 Bottom rail
7 Bottom rail cap
8 Wood screws
9 Drywall anchors
WARNING
Additional tensioning
may be required
Fig.1
Fig.2
QTY
1
2
1
1
1
1
2
4
4