Using The Tool; Sander Specific Warnings - hamach HD 75 Instrucciones De Uso

Using the tool

• Always wear eye protection when operating or performing maintenance on this tool.
• Always wear hearing protection when operating this tool.
Keep bands, loose clothing and long hair away from rotating end of tool
•
Anticipate and be alert for sudden changes in motion during start up and operation of any
•
power tool.
• Keep body stance balanced and firm. Do not overreach when operating this tool. High reaction
torque's can occur at or below the recommended air pressure.
Tool shaft may continue to rotate briefly after throttle is released.
•
• Air powered tools can vibrate in use. Vibration, repetitive motions or uncomfortable positions
may be harmful to your hands and arms. Stop using any tool if discomfort, tingling feeling or
pain occurs. Seek medical advice before resuming use.
Use accessories recommended by EMM.
•
This tool is not designed for working in explosive atmospheres.
•
• This tool is not insulated against electric shock.
• Every 160 hours of tool operation, remove sanding pad from spindle and inject 1 or 2 strokes
of grease through the end of the spindle to lubricate the needle bearing in the counter-weight.
Do not carry the tool by the hose.
•
Please oil this tool regular.
Notice
The use of other than genuine EMM replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorised trained personnel. Consult your nearest EMM Dealer.
Refer all communications to the nearest EMM dealer.

Sander specific Warnings

These sanders will operate at the free speed specified on the label if the air supply line
•
furnishes 6,2 bar / 620 kPa air pressure at the tool. Operation at higher air pressure will result
in excessive speed.
• Use only a sanding pad , buffing wheel or polishing bonnet with these tools. Do not use any
grinding wheel, bur or metal removing accessory with these tolls. Never use an accessory
having a maximum operating speed less than the free speed of the sander in which it is being
used.
•
When using a pad having a shank, insert the shank to full depth in the collet. When using a
pad on a threaded arbor, make certain the flange nut is tightened securely. Check the
tightness of the collet nut or flange nut before operating a sander to make certain it will not
loosen during operation.
7