Status Leds; Manual Mode; Technical Specification - Greenice THEBEN FIX 2 DM 4 T KNX Manual De Instrucciones

Status LEDs

LED 1
LED 1, 2
LED 1, 2, 3
LED 1, 2, 3, 4
LED 2, 3, 4 Flickering
LED 1, 2, 3, 4 Flickering

Manual mode

Push man bottom man ② (LED turns on).
STEP 1.
Push the channel bottoms ③.
STEP 2.
Dimming values manual adjustment
Each channel is allowed to operate with 4 bottoms (from left to right)
Bottom 1
Bottom 2
Bottom 3
Bottom 4
Installation is recommended with a separation of 8mm on both sides.

Technical specification

 Voltage: 230 VAC +10% - 15%.
 Frequency: 50Hz.
 Minimum standby: 0.9W.
 Outside temperature permitted: from -5
 International protection marking: IP20, EN 60529.
 Load: R/L/C.
 Incandescent bulbs power: 400W.
 Inductive load: 400W.
 Electronic transformers: 400W.
 Dimming energy saving lamp power: 80W.
 230VAC Dimming LED lamp power: 60W.
 Permitted load while parallel connection:
Incandescent bulbs power: 1x800W.
Dimming energy saving lamp power: 1x140W.
230VAC Dimming LED lamp power: 1x120W.
 Pollution degree: 2.
 Permitted peak voltage: 4kV.
Dimming until 25%
Dimming from 25% to 50%
Dimming from 50% to 75%
Dimming from 75%
Overheated
Short circuit
On: 25%, Off: 0%
50%
75%
100%
0 0
C to + 45 C.
6