Colorist POD 1Qa Guía De Referencia Rápida página 5

Colorist Pod 1Qa QRG
Ilumicode
Connections
Ilumicode
Connection
Diagram
This diagram shows how to control multiple products at the same time.
All connected products will be assigned to the same DMX address. To
assign individual DMX addresses to each product, connect the Ilumicode
to each product individually. Be sure to disconnect the DMX output of
the product being configured if other products are connected to it.
Power
Signal
DMX Output
Ilumicode
Addresser
When connecting the Ilumicode Addresser to the Colorist Pod 1Qa,
it may be necessary to use a male 3-pin to female 5-pin adaptor (sold
separately).
1: Gnd
2: Data –
3: Data +
5
EN
To
Other
Products