Publicidad
Idiomas disponibles
Idiomas disponibles
Eng
GliderCG
How to use
1º - Place GliderCG on a smooth and level surface.
2º - Verify that there is no object or weight in the device.
3º - Turn on the device with the switch located to the left.
After a few seconds a welcome message is displayed on the OLED screen that gives
way to another screen with two lines "Weight:" and "CG:"
Due to the high resolution and sensitivity it is possible that at the start of the measure-
ment the weight is nonzero. In that case it´s necessary to verify that it is static on a at
and level surface and must be turned o and then on again until the initial measure is
zero.
4º - When these lines appear (Weight and CoG) we can proceed to place our sailplane
so that the fuselage is between the four supports of our device and the leading edge
of the wing to stop with the vertical metallic supports like is shown in the following
gure:
5º - Now the display show an accurate reading of our CoG and the weight of our
model.
6º - On the model itself you can make the necessary adjustments to locate your CoG in
the place you wish, GliderCG will give you the reading of your position at any time.
7º - Once the adjustments are completed you can proceed to remove your model from
the device and turn it o using its ON/OFF switch.
8
Publicidad
