4 Using the Tray Insert
The tray insert is removable and dishwasher safe.
• To remove the tray insert, pull outward and upward on the hook attachments on both sides of the tray insert. See Figure 4.1. Be sure to lift
straight up to avoid spilling anything on the tray insert.
• To attach the tray insert, fit the tray insert into the tray until both sides snap into place.
5 Securing the Child in the Seat
There are 2 height adjustment positions for the shoulder harness. Adjust the height to the closest height above your child's shoulders.
• To remove the shoulder harness, turn the plastic ends sideways and push them through the slots in the seatback. Re-attach the harness
at the proper height by reinserting the plastic ends through the slots. See Figure 5.1. Ensure both straps are the same height.
• To unlatch the buckle press the center button and remove the male ends of each buckle. See Figure 5.2.
• Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the
child's legs.
• Push the shoulder/waist latch posts into the crotch buckle until all parts snap into place. See Figure 5.3.
• Tighten the waist belt to be snug around the child's waist.
• The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings on these straps.
6 Folding the High Chair
NOTE: The high chair can be folded with the tray and tray insert attached. Be careful to keep your fingers from being pinched by moving parts.
• Keep children away from high chair while folding.
• Orient the high chair diagonally in front of you.
• Slide the secondary lock all the way across and lift up on the folding mechanism behind the top of the seat back. See Figure 6.1.
• Rotate the seatback down towards the ground until the high chair is completely folded. Note that the high chair does not lock into the
folded position.
• To carry the high chair, grab the handle on the rear of the seat bottom and go.
Maintenance
All of the fittings, snaps, locks, rivets, and other hardware and plastic parts on the high chair should be inspected periodically to ensure
that they are secured properly and not damaged or malfunctioning. The restraint system, as well as all other fabric items and their stitching
should also be inspected periodically to ensure that they are secured properly and not loose, torn or otherwise damaged. All moving parts,
such as the tray and hinges should also be checked periodically to ensure they are operating properly.
Any missing, broken, or worn components should be replaced immediately, and the high chair should not be used until they are replaced.
Only original manufacturer's components should be used. If needed, please contact Joovy at our toll-free phone number.
Cleaning
The fabric material on the high chair can be cleaned using mild household soap or detergent and warm water on a sponge or clean cloth.
Always allow the fabric to completely air dry before using or storing the high chair.
We want you to be completely satisfied with your purchase of this product. Should you experience any difficulty in
assembling or using this product, or if you have any questions, please contact our Customer Service Department:
UNITED STATES - Joovy: (877) 456-5049, Hours 8:30 am – 5:00 pm Central Time.
CANADA - ISSI Inc.: (800) 667-4111, Hours 8:30 am – 5:00 pm Eastern Time.
WARNING
!
Prevent serious injury from falls or sliding out.
Always use the restraint system.
SATISFACTION GUARANTEED
Please log onto www.joovy.com to register your new Joovy product.
EN
FR ES