Cequent Performance Products 76080 Instrucciones De Instalación página 4

Remove screws using T15 Torx bit – Remove (3) screws exposed at wheel well liner.
Remove (2) screws from the middle underside area of the fascia. Do the same on both
sides of vehicle.
Open the liftgate, remove (2) phillips screws from fascia one each side.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Gently pry/pull off the body trim piece at the upper wheel well (Figure 2) to expose (1)
screws to be removed, using 7mm socket. Note: Plastic body panel removal tools
suggested to ease removal.
Remove taillights, pry off screw covers to expose T15 screws, (2) each side. Pull taillights
gently rearward to release, unplug and set aside.
Sheet 4 of 18 76080NP 7-15-16 Rev. A