IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these instructions in a handy location.
They contain important safety information.
Read all warnings and instructions before you
start to build and operate the model.
WARNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
CAUTION: Keep hands, face, hair
and clothing away from all moving
parts.
CAUTION: Be careful not to tip the
model over. Model should be placed
on a flat and hard surface.
•
Share the K'NEX experience with
your child and make building with
K'NEX a family fun adventure.
2
•
Take your time to enjoy the building
process. Don't rush!
•
While you're building make sure you
face your model in the same
direction as the pictures show in
the instructions.
•
Be sure to install batteries into
the motor before you start building
the motorized models.
•
Product and colors may vary.
CONTENTS
DRAGON'S DROP COASTER . . . 4
Track Building Tips . . . . . . . . . . . . . . . . . . . . . . . .
Attaching Coaster Cars and Graphic Panels . . . . . .
Tips & Troubleshooting . . . . . . . . . . . . . . . . . . . . .
RACING THRILL WHEEL . . . . . 50
BATTERY
INFORMATION
Caution: To Avoid Battery
Leakage
•
Be sure to insert the batteries
correctly and always follow the toy
and battery manufacturers'
instructions.
•
Do not mix old and new batteries
or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium)
batteries. Only batteries of the same
or equivalent type recommended
should be used.
•
Always remove weak or dead
batteries from the product; do not
short-circuit supply terminals.
•
Insert batteries with correct polarity
(+/-) as shown.
Important Tips
•
Alkaline batteries AA (LR6) are
recommended.
•
Rechargeable batteries are not
recommended.
•
Remove rechargeable batteries from
toy before charging; they must be
charged only under adult
supervision.
•
Non-rechargeable batteries must not
be recharged.
29
48
49
•
Keep components free of dust; do not
immerse or use in water.
•
Do not dispose of batteries in a fire;
they could leak or explode and cause
injury.
•
Remove all batteries if the toy will not
be used for a long period of time.
•
Do not put Rods smaller than
2 inches in any openings of the
motor; they will damage the motor,
and cannot be removed.
How to Insert and
Remove Batteries
•
Use a small Phillips head screw-
driver to loosen the screw. Insert 2
fresh AA batteries (LR6) into the
compartment with the correct
polarity (+/-) as shown here.
+
-