Cequent Performance Products 76022 Instrucciones De Instalación página 4

1. Fascial door removal – use 7 mm socket to remove (2) bolts from fascia door, see Figure 2.
Keep the fasteners and door for reinstallation.
2. Hitch installation – insert pull wires ⑤ from the largest round hole of frame
rails, see Figure 3, and then use them to feed carriage bolts ① and spacer ②
into frame rails. Use a die grinder to enlarge the feeding hole if necessary. Leave
pull wires attached. Raise the hitch into position and feed carriage bolts through
bracket holes, see Figure 1. Remove the pull wires and loosely install hex nuts
④ and conical washers ③ to the hitch.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 4 of 15 76022NP 05-10-16 Rev. A