Temperature Setting - Infiniton FGC-320W Manual De Instrucciones

Note：Figure 1, Figure 2 only as a product space demand size schematic diagram.
3.Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to vibration and noise.
When the refrigerator is placed on such flooring materials as carpet, straw mat, polyvinyl chloride, the solid backing plates
should be applied underneath the refrigerator, so as to prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
Preparations for use
5. Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to energize the
refrigerator after more than 1 hour of standing, so as to ensure its normal operation.
6. Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
7. Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the temperature inside
the freezer compartment drops obviously, it indicates the refrigeration system is working normally.
8. Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be automatically controlled
according to the user's temperature setting. After the refrigerator is fully cooled, put in foods, which usually need 2~3
hours to be fully cooled. In summer, when the temperature is high, it takes more than 4 hours for the foods to be fully
cooled (Try to open the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage circuit
breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall gets blackened
by air convection around the compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver, television set surrounding it, so
try to keep the refrigerator as far away as possible in such case.
XIV. Functions
When the refrigerator system is powered on for the first time, all icons on the display panel gets illuminated for 2s, and the
system runs at 4℃ by default.
1. Functions

1.1 Temperature setting

Operating environment
In summer (higher than 35℃)
Normal condition
In winter (lower than 13℃)
When foods need to be frozen
fast.
Temperature can be adjusted by pressing the 'SET' key, and if no key operation within 3s after temperature setting, the
said setting will be validated, with the temperature immediately controlled as per the setting; and the mode indicator light
will go off after 3 seconds.
The temperature modes cycle as following: "2→4→6→8→FAST COOL→2"
Fridge temperature setting on the display panel (Modes 2, 4, 6 and 8)
Suggested Mode(s)
4，6，8
4
2，4
Fast Freeze
Method
Press the "SET "key for adjustment.