Publicidad
Installation
1 Attach the TEMPLATE on the CEILING BOARD and drill a guided hole.
2 Remove the CABLE HOLE CAP and the HEX NUT with a tool such as a coin.
(SHP-1560FPW only)
3 Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the
ANCHOR BOLT as below:
1.
Tighten the NUT ("N1") on the ANCHOR BOLT.
2.
Insert the provided SAFETY BRACKET into the ANCHOR BOLT.
3.
Tighten two NUTs ("N2", " N3") onto the ANCHOR BOLT.
4.
Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
5.
Hook and fix the other end of SAFETY WIRE onto the HOUSING as shown below:
Nut (N1)
SAFETY BRACKET
Nut (N2,N3)
ANCHOR BOLT
SAFETY WIRE
CEILING
CEILING
SHP-1560FPW
I
`
The ANCHOR BOLTs and nuts are optional and not included in the product package.
`
ANCHOR BOLTS must be able to sustain the weight of at least 30 kg.
`
If you proceed without following the instructions in the manual, that is if you work with the
camera body already attached from the beginning, the safety wire could exceed its limit and
be broken when the housing is accidentally dropped, which could result in an accident.
4 In the case that the pipe is to be connected to the External Cable hole, the pipe must
be inserted within the depth of 15mm or less. (SHP-1560FPW only)
Less than 15mm
5 To connect to the camera, insert the network cable through the cable hole on the
housing to the inside of the housing as shown in the figure.
6 Push the HOUSING inside the CEILING through the CEILING hole, and tighten the
SCREWs (x3) clockwise to fix the HOUSING on the CEILING.
(Adjust the height of the bracket to secure the housing to the ceiling.)
CABLE HOLE CAP
BRACKET
HEX NUT
I
`
Using a power tool for installation could cause product damage.
If you are going to use a power tool, the torque must be 30 Nm or less.
`
Ensure that the HOUSING is firmly secured to the CEILING BOARD.
7
Hang the SAFETY WIRE inside the housing on the SAFETY WIRE HOOK of the camera.
SAFETY WIRE
ANCHOR BOLT
SAFETY WIRE HOOK
HOUSING
8
Refer to the camera user manual to connect the network cable to the camera.
9
As shown in the figure, align the direction of the camera logo and INSTALLATION DIRECTION
GUIDES (△) of the housing, and then turn it in the direction of the arrow as you push the
camera upward to join them.
SHP-1560FW
SHP-1560FW
SHP-1560FPW
BRACKET
CEILING
INSTALLATION DIRECTION GUIDES
View from the top of the housing
Assembling the Top Cover (SHP-1560FW)
1 Mount the TOP COVER to the HOUSING.
I
`
To use as a Smoke Dome, please purchase and replace the SPB-PTZ85W Dome cover
separately.(SHP-1560FW, SHP-1560FPW)
TR20
Assembling the Top Cover (SHP-1560FPW)
1 Attach the TOP COVER to the HOUSING, and tighten the four SCREWS
on the COVER to fix it to the HOUSING.
2 Insert the SCREW CAPS into the screw holes.
TR20
SCREW CAP
PT01-005721A_(v1.1)
Publicidad
