How To Bypass Zones; Using A Chime; Control For Outputs And Devices - Siemens IC60 Manual De Usuario

Using the system
3.10

How to bypass zones

3.11

Using a chime

3.12

Control for outputs and devices

12
Building Technologies
Fire Safety & Security Products
Arm Partition A or B
1. Press and hold <A> or <B> during two seconds to ARM the desired partition.
During the exit delay you can leave the premises. If you wish to stay or if you do not want anybody
to enter the protected premises, you may cancel the Entry/Exit delay by pressing the <ENTER>
key.
2. The slow beeping stops and the partition is armed immediately.
The <ARM> indicator lights up to indicate that the partition is armed.
The indicators may go out after a few seconds, depending on the installer's setting
Used keys:
<BYPASS>
Bypass any zone that cannot be closed. You may bypass selected zones prior to
arming. This feature is also used to temporarily exclude a faulty zone requiring re-
pair from service.
1. To bypass a selected zone, press <BYPASS>
The Bypass indicator lights up to indicate that the system is in bypass mode.
2. Enter the zone number (e.g. 01, 05, 16) for one or more zones
3. , Press <ENTER>
The Bypass button flashes to indicate bypassed zone(s).
To disable the bypassing of zones, press <BYPASS>, enter the zone number (e.g. 07, 13), then
press <ENTER>
Note: Disarming means that the bypassing of all zones is automatically disabled.
A chime (day zone) is a detector that can be partly armed while you are at home
but working in another part of the building. It can be programmed to operate a
buzzer or light to let you know that you have a visitor.
To enable the Chime mode press <♫>.
To disable the day (chime) zone, press <♫>
The keypad enables you to control external devices, such as an air-conditioner or
heater. To activate or stop a device:
1. Press <CTRL>.
2. Press the number of the output. (Up to eight different outputs can be controlled
via the keypad).
3. Press <ENTER>
This activates or deactivates the selected device.
4. Press <CTRL>.
5. Press <ENTER>to return to normal mode.
08.2007