Publicidad
Idiomas disponibles
Idiomas disponibles
@IU6GÃHP @GÃUSDHH@SÃ
,16758&7,216 )25 86(
± 6WRSSLQJ DQG HPHUJHQF\ VWRS PRGHV
The appliance can be stopped as follows:
-
pushing the mushroom-head stop button (11, Fig. 2b), which
completely interrupts power supply to the appliance;
-
by unplugging the power cable from the mains socket outlet.
:DUQLQJ
DO NOT ABANDON THE APPLIANCE WHILE IT IS RUNNING AND
REMEMBER TO SWITCH IT OFF WHEN YOU FINISH WORKING WITH IT.
IF YOU NOTICE MALFUNCTIONS STOP THE APPLIANCE IMMEDIATELY
AND DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY.
BEFORE RECONNECTING THE POWER SUPPLY FIND THE CAUSE OF
THE FAULT AND REMEDY IT. IN THE CASE OF PROBLEMS, CONSULT
CARLO DE GIORGI.
0$,17(1$1&(
Any maintenance work on the electrical parts inside the appliance casing
must be performed exclusively by authorized and suitably skilled
personnel. Note that the appliance carries dangerously high voltage which
represents a hazard if maintenance is performed on the electrical
components without first disconnecting the power supply.
± &OHDQLQJ DQG OXEULFDWLRQ
The appliance does not require particular maintenance with the exception
of regular cleaning of the working area: before cleaning the appliance
always disconnect it from the power supply.
± &KDQJLQJ WKH JULQGLQJ GLVN
To replace the grinding disk proceed as follows:
a) disconnect the appliance from the electrical power supply;
b) remove the disk guard by unscrewing the four screws at the rear (3,
Fig. 1) using the 4 mm Allen key supplied with the appliance;
c) immobilize the motor shaft at the rear (4, Fig. 1) using the 6 mm Allen
key supplied with the appliance, and then unscrew the screw at the
front of the appliance using an M 13 wrench;
d) remove the worn grinding disk (10, Fig. 2b) (the grinding disk can also
be inverted so that the rear face can be used), fit the new disk or invert
the original one and tighten the screw at the front while holding the
motor shaft with the Allen key; refit the disk guard.
8h…y‚ÃqrÃBv‚…tvÃ
@IÃÃ(Ã
Publicidad
