Ups Outputs; Battery And Charging; Main Features; Unattended Operation - ACT AC2300 Manual De Usuario

3.3 UPS outputs

The AC2300 UPS has 6 outputs:
• At the left side three outputs for power failure (surge/spike) protection.
At the right side three outputs for power failure (surge/spike) protection with a
•
backup function when AC fails. The built-in battery will continue to supply power
for the connected equipment.
The AC2305 UPS has 2 outputs 1x IEC (C13) + 1x EU socket type F female:
Both outputs are for power failure (surge/spike) protection with a backup function
when AC fails. The built-in battery will continue to supply power for the connected
equipment.

3.4 Battery and Charging:

• When the UPS is connected to AC, the charger will charge the battery fully in
about 10 hours.
When the battery is used up, please turn off the UPS and charge the battery for a
•
least 10 hours when. Then turn on the UPS

4.0 Main Features

4.1

Unattended Operation

• Please connect the UPS to AC and press the ON button on the front panel, the
UPS is turned on and the AC outputs stabilized voltage.
When AC fails, UPS will supply power to the equipment immediately. And when
•
the battery is used up, UPS will turn off automatically.
• When AC comes back, UPS will turn on automatically.

4.2 Protection

Battery discharge protection: when the battery discharges and the UPS is in
•
inverter mode, the UPS will check and monitor the working status of the battery;
when the battery voltage drops to the limited lowest voltage, the inverter will turn
off automatically and protect the battery; When AC comes back, the UPS will
turn on automatically.
Short-circuit Protection: when the UPS is in inverter mode and there is shock or
•
short-circuit, UPS will output limited currency, protecting the UPS( When in AC
mode, the UPS will be protected first by input fuse and then transfers to the
inverter working mode).
5 |
ENGLISH