ASROCK K7VM3 Manual Del Usuario página 10

2.5 Connectors 2.5 Connectors 2.5 Connectors
2.5 Connectors 2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.2 item 19)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 item 10)
Connector this BLUE end
to the motherboard
Note:To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB 2.0 header
(9-pin USB45)
(see p.2 item 20)
Infrared module connector
(5-pin IR1)
(see p.2 item 21)
Internal audio connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.2 item 29)
(AUX1: see p.2 item 30)
1 0 1 0 1 0
1 0 1 0
Figure
Secondary IDE connector (Black)
(39-pin IDE2, see p.2 item 9)
80-Pin ATA 100/133 cable
AUX1 CD1
ASRock K7VM3 Motherboard
Description
red marking
Connect this BLACK end
to the IDE devices
TM
ASRock I/O already
provided 4 default USB 2.0
ports. If the 4 USB 2.0 ports
on the rear panel are not
sufficient, this USB 2.0 header
is available to support 2
additional USB 2.0 ports.
This connector supports an
optional wireless transmitting
and receiving infrared module.
These connectors allow you
to receive stereo audio input
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.