Operational Summary - Bushnell Yardage Pro X 500 Manual Del Usario

OPERATIONAL SUMMARY

While looking through the monocular, depress the power button once to activate the inview
display system (LCD). Aim the Yardage Pro X500 at a target at least 5 yards away, depress
and hold the power button down until range reading is displayed. Release the power button.
Note: Once activated, the Yardage Pro X500's LCD will remain active and display the last
distance measurement for 30 seconds. You can depress the power button again at any time
to distance to a new target. As with any laser device, it is not recommended to directly view
the emissions for long periods of time with magnified lenses.
FEATURES
Your Yardage Pro X500's LCD incorporates illuminated indicators that advise you unit of measure, when the laser is
active, the battery charge is low, and when a target has been acquired. A summary of these features is presented below:
UNIT OF MEASURE OPTIONS – The Yardage Pro X500 can be used to measure distances in yards or meters. The
unit of measure indicators are located in the lower right portion of the LCD. To select between yards and meters, remove
the battery cover slide. Locate the internal yards to meter slide switch. To measure in yards, slide the switch to the "Y"
position. To measure in meters, slide the switch to the "M" position.
ILLUMINATING INDICATORS – Low Battery Charge ( ) When the low battery symbol is displayed in
the upper right-hand portion of the LCD, the battery charge is getting low and the 9-volt alkaline battery should be
replaced.
TARGET ACqUIRED: Informs the user that a distance measurement has been obtained. The message "TARGET
ACqUIRED" will appear in the top portion of the LCD. The distance measured will appear at the bottom of the
LCD in numerical form.
4