Sage Nutri Juicer Cold Plus Manual Del Usuario página 11

Motor appears
to stall when
overload protection
LED flashes
Overload protection
LED light flashing
during the use
Overload Protection
LED is on
If any of the above issues persist, or if you have questions, stop use of the juicer and contact
Sage Customer Service.
®
Guarantee
2 YEAR LIMITED GUARANTEE
AND 5 YEAR LIMITED MOTOR
GUARANTEE
Sage Appliances guarantees this product for
domestic use in specified territories for 2 years for
all parts of the product and 5 years for the product's
motor from the date of purchase against defects
caused by faulty workmanship and materials.
During this guarantee period Sage Appliances will
repair, replace, or refund any defective product (at
the sole discretion of Sage Appliances).
• Wet pulp can build up under the juicer cover and stall the juicer if the juicer
is used excessively without cleaning. If this occurs, disassemble and follow
the cleaning instructions to clean the filter bowl surround, the stainless
steel filter basket and the juicer cover. The juicer can also stall if excessive
force is used to push produce down the feed chute. If this occurs, ensure
that a more gentle pressure is used to push produce down the chute.
• The juicer will automatically stop operating if too much food is being
processed at one time. Try processing a smaller amount per batch. To
continue juicing, reset the juicer by turning the juicer OFF and back ON.
• Turn on the juicer before putting ingredients in the chute. Pressing
ingredients down before the juicer reaches full speed can cause the motor
to stall or overload. Use gentle to moderate pressure on the pusher. Lower
pressure produces a better juice yield.
• Hard fruit and vegetables will put excess strain onto the motor if a low
speed is selected. Refer to the juicing guide to determine the correct speed
for the fruit and vegetables selected for juicing.
• This indicates the motor speed is slowed down to an inefficient level.
This may be caused by excessive pushing force on the pusher or too much
pulp building up on the lid or in pulp pin. Use moderate pushing force on
the food pusher and regularly clean the lid and pulp bin to ensure the juicer
is operating at optimal speed.
• This indicates motor overload protection is activated. To reset the unit,
turn the dial to OFF, unplug the juicer and let the motor cool down for
25–30 minutes, then plug the juicer back in.
All legal warranty rights under applicable national
legislation will be respected and will not be
impaired by our guarantee. For full terms and
conditions on the guarantee, as well as instructions
on how to make a claim, please visit
www.sageappliances.com.
EN
11