Vision SIMATIC VS130-2 Instrucciones De Montaje página 9

Wiring Components
Connect the processing unit with the other components using the connectors on the front
panel. The pinning of the connectors is described in Appendix 8.5.
Attention
!
Do not connect or disconnect cables when the power supply is on.
Apart from the Ethernet cable, the cables are supplied with the product (See Appendix 8.1).
Warning
!
Grounding the VS130-2/VS 130-2vcr cancels the ungrounded installation of the power unit
used to operate the VS130-2/VS 130-2vcr.
IN DC 24V LAMP
Connector Connector Type
Label
Functional earth - Screw terminal
Power supply IN 24 V DC Circular connector M12
Lighting Unit LAMP Circular connector M12
Sensor head SENSOR HD D-sub *
(shielded cable)
I/O DI/DO D-sub
PROFIBUS DP DP D-sub
Ethernet Ethernet RJ45
* The supplied ferrite ring must be fixed to the sensor cable (approx. 50 mm from connector
to processing unit).
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr - Installation Instructions
A5E00475766-01
DP ETHERNET
Number Cable Type
of pins Cross
Section
- - -
2
4 0.56 mm Pin
2
4 0.23 mm Socket
2
26 0.09 mm Socket
2
15 0.14 mm Socket
9 - Socket
8 - Socket
Step Activity
1 Read the guidelines on preventing electrical interference (refer to the manual, Section 3.3).
2 Connect the processing unit to the sensor head and the lighting unit with the cables.
3 If you do not evaluate the result bits READ, MATCH, N_OK over PROFIBUS DP: Connect
the digital outputs READ, MATCH, N_OK as described below ("DI/DO" I/O interface).
4 Connect the trigger signal via the TRG digital input.
5 If you intend to control the SIMATIC VS130-2/VS 130-2vcr with a PLC via the I/O interface
"DI/DO", connect the other digital inputs and outputs as described below (DI/DO interface).
6 Connect functional ground of the processing unit to chassis ground
(Diameter of the ring: (M5, cable cross section 1.5 mm
7 Connect the processing unit to the 24 V power supply (2 A).
8
Connect the PC/PG to the processing unit via Ethernet.
If you want to use this connection as a direct connection, please note that a crossover cable
is necessary.
Note
The DC load power supply must meet the following requirements:
Only low voltage less than or equal to 24 V DC safely isolated from the power
supply network must be used for the load current supply. Safe isolation can be
implemented, for example, by adhering to the specifications in VDE 0100-410 /
HD 384-4-41 S2 / IEC 60364-4-41 (functional low voltage with safe isolation) or
VDE 0805 / EN 60950 / IEC 60950
(as safety extra-low voltage SELV) or VDE 0106 Part 101.
Note
The supply chassis of the I/O and CPU must be connected to the supply chassis
of the processing unit.
2
).
3