Safety Instructions - Metal Works CATM10CLIP Manual

Composition

Safety instructions

• Never exceed the maximum load capacity of the ram
• Do not over extend the ram, as it is possible to force the plunger out of the top of the ram
• When coupler valves are disconnected, always insert dust cap to keep the oil lines clean.
• If the load is not centred to the ram plunger, pump carefully. If you have to use excessive pressure to pump
the ram, stop the operation and adjust the set-up so that the load is more central. This should decrease the
effort required.
• Do not drop any heavy objects onto the hose, and do not allow the hose to kink.
• Always allow clearance for the hose to avoid damage to the hose and couplers.
• Keep the equipment away from heat or fire, as this may damage or weaken the equipment.
Use
Pump unit
1. Connect the hydraulic ram and pump unit hose together, ensure you have
securely fastened the couplings before pumping.
2. Firmly close the release valve A by turning it in a clockwise direction. Fig. 1.
3. Apply pressure to the pump B by pumping the handle up and down. Fig. 1.
4. To release the pressure turn the valve anti-clockwise.
Note: The pump can be used in any position in horizontal to vertical. Always
keep the hose end of the pump unit facing downwards when positioned
vertically. Fig. 2.
Attachment combinations
The pump unit can be used with the multidirectional ram. This enables many
accessories combinations, some which are shown on page 10
6
®
CATM10CLIP - NLFRENES - v1.1 - 30092013
1. Plastic storage case
2. 685 mm extension bar
3. 455 mm extension bar
4. 250 mm extension bar
5. 100 mm extension bar
6. Serrated cap
7. Hydraulic spreading wedge
8. Rubber head 800 mm
9. Flat serrated base
10. Ram toe
11. Plunger toe
12. Cleft head
13. 'V' base
14. Double end male snap
connector
15. 10 T pump unit
16. Hydraulic push ram unit
17. Hydraulic hose
Afb. 1
Afb. 2
EN
B
A