Vollrath JW30PA Manual De Operador página 3

CLEANING
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the equipment. These can damage
the finish.
TROUBLESHOOTING
Problem
Oven does not heat.
Oven repeatedly overheats.
35 Inch Plate Activated Cheese Melters Operator's Manual – Model JW30PA
Might be Caused By
Oven is not plugged in.
There is not a plate on the shelf.
The wall breaker may be tripped.
The reset may be tripped.
One or more heater tubes may have
burned out.
There may be a problem with the
pressure switch.
The fan may be dirty.
There may be a problem with the fan.
1. Press the On/Off switch to the OFF position.
2. Unplug the oven.
3. Let the oven cool completely.
4. Slightly dampen a soft cloth with a warm water.
5. Use the dampened cloth to clean the interior and exterior of the
oven, and the air intake on the side of the oven
6. Remove the shelf and clean with warm soapy water.
Course of Action
Plug in the oven.
The oven is plate activated. Place a plate on the shelf.
Reset the breaker.
Look on the side of the oven to see if an object is preventing the fan
blades from turning.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven cool.
4. Remove the object.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
Inspect the fan blades to see if they are dirty.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven cool.
4. Clean the fan blades.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
Contact Vollrath Technical Services.
Verify the fan blades are clean.
Run the oven for 10 minutes. If the fan does not run, contact
Vollrath Technical Services.
3