Replacing The Remote Control Battery; Troubleshooting - Insignia NS-M10OHD Guia

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the remote control battery

If the remote control does not function, or if the
operating range becomes reduced, replace the
old battery with new one.
To replace the battery:
1 Slide the battery holder to the right (as
shown) while at the same time pulling it away
from the remote control.
2 Remove the old battery, then place the new
lithium battery with the (+) side up in the
battery holder. (Use battery type CRD2025.)
3 Slide the battery holder back into the remote
control until it clicks into place.
Note
• Dispose of the used battery correctly.
• Do not misuse the battery by shorting the
positive + and - negative terminal or putting it
into fire which may cause the battery to
explode.
• The battery and battery holder can be a
choking hazard. Keep the remote control away
from young children.
12

Troubleshooting

Problem
The player suddenly
stopped working or
the screen went
black.
Player doesn't turn
on.
Player operates
erratically.
Player does not play
disc.
Picture skips
occasionally.
Picture is blurry.
Picture is too dark.
No sound from
headphones.
www.insignia-products.com
Cause
Solution
Player error.
Try turning the
player off and on. If
the player still
doesn't respond,
press the reset
button.
The car ignition (or
Insert the key into
ACC/Accessory) is
the ignition and turn
off.
it to ACC/Accessory.
Condensation in the
Wait for about one
player.
hour or until
condensation
evaporates.
Remote control
Replace the battery.
battery needs
replacing.
Dirty IR window on
Clean the player's
the player or remote
and the remote
control.
control's IR
windows.
Loose connections.
Check and tighten all
connections.
Disc is inserted
Reinsert the disc
incorrectly.
with the label side up
(facing the ceiling).
Disc is dirty or
Clean or replace the
scratched.
disc.
Disc format is not
Check the disc
supported.
format.
Regional code of DVD
Insert a Region 1
doesn't match the
DVD.
player's regional code
(Region 1).
Disc is dirty or
Clean or replace the
scratched.
disc.
Interference.
Move the vehicle
away from the
interference.
The player is too
Wait for a few
cold.
minutes until the
player warms up.
Brightness is set too
Adjust the
low.
brightness setting.
Wireless headphones
Turn on the
are not turned on.
headphones.
Headphone batteries
Replace or recharge
are too low.
the batteries.
An object is blocking
Remove the
the line of sight
obstruction or move
between the IR
closer to the
headphones and the
transmitter.
IR window on the
player, or the
headphones are too
far away from the
player.

Publicidad

Tabla de contenido
loading

Tabla de contenido